Leg Sensors and a Catch                                                                  

Pressure sensor amp circuit.

I built two small amplifier boards for the piston pressure sensors and mounted them in boxes attached at the top/back of the piston body. The circuit converts the tiny millivolt differences that are produced by the pressure sensors into voltages that the Arduino is able to understand. For every one PSI of pressure inside the piston, there is a 0.1 volt increase in the amp output, starting at a value of 1.000 V for no pressure at all. So piston air pressure of 10 PSI gives an output of 2.000 volts. This value corresponds to a force of 70 pounds being exerted by the leg. A maximum voltage of 5.00 (40 PSI) would indicate 280 pounds of force per leg. 

Rotation sensor.

I attached a small magnet to a bracket on the lateral side of the “thigh bone” such that the magnet rotates about the “hip” axis as the upper leg moves. The direction of the rotating magnetic field is picked up by a stationary Hall effect sensor (Mouser 771-KMA199ET/R $6.99) and is converted to an analog voltage signal between 0 and 5 volts.

The legs have no powered mechanism to move them from front to back or from back to front. The legs dangle on the hip axel in any way they want! So just how is it that I’m planning to have these legs pull me in a cart?

Leg movement simulation.

As the cart moves forward, the legs move backward and, if the “foot” is behind the line of the hips, then a component of the vertical weight on the leg is directed as a forward force in the direction of travel. Basically the leg is falling forward and it’s taking the cart with it. The leg must keep extending if the cart height is to be kept constant. The other leg better be in place to begin the next step before the first leg gets to the end of it’s travel or the legs will trip and hit the ground. To swing a leg forward rapidly though the air, the leg’s knee must be sufficiently flexed such as to not hit the ground on the way forward. 

Catch mechanism.

This bending of the knee takes a moment, during which time the leg cannot be permitted to swing forward as of yet. So there is a mechanical catch in the err... “inner thigh” region that engages as the leg extends backwards past a certain point and keeps the leg from moving forward. The catch remains engaged until it is released by the action of the knee flexing backwards to a nearly 90º position. The flexing of the knee back and up, increases the leg’s potential energy such that when the catch is released the leg now swings fully forward and can be redeployed in a forward position. If the foot is deployed in front of the line of the hips, then very little pressure is applied to the ground (unless it is desired to slow down or stop the cart). This is the plan anyway.

The building of the legs is done. Time to hook the legs up to the Arduino, here in the doghouse, to do a few tests and to collect some data.